End Of Cycle; Fluff In The Drum; Draining Water Out After End Of Cycle; Auto Stand-By Function - John Lewis JLWD 1613 User Manual

3. Close the door and press the Start/Pause
button.
The programme or the delay start continues.

End of cycle

When the programme has finished, the
appliance stops automatically. The acoustic
signal operates (if it is active).
In the display comes on and the door locked
indicator goes off.
The indicator of the Start/Pause button goes
off.
1. Press the On/Off button to deactivate the
appliance.
5 minutes after the end of the programme, the
energy saving function automatically deactivates
the appliance.
When you activate the appliance
again, the display shows the end of
the last set programme. Turn the
programme knob to set a new
cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew and
odours

Fluff in the drum

During the washing and/or drying phase, some
types of fabric, (sponge, wool, sweatshirt) could
release fluff.
The released fluff could stick to the fabrics
during the next cycle.
To prevent fluff in your laundry, we recommend
that you:
• Do not wash dark fabrics after you have
washed and dried light coloured fabrics (new
sponge, wool, sweatshirt ) and vice versa.
• Line dry these types of fabrics when they are
washed the first time.
• Clean the drain filter.
• Clean the empty drum, the gasket and the door
with a wet cloth after the drying phase.
26
Draining water out after end
of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to reduce creasing.
The door lock indicator
stays locked.
You must drain the water to open the door:
1. If necessary, decrease the spin speed.
2. Press the Start/Pause button.
The appliance drains the water and spins.
3. When the programme is completed and the
door lock indicator
the door.
4. Press the On/Off button for several seconds
to deactivate the appliance.
The appliance drains and spins
automatically after approximately
18 hours.

Auto Stand-by function

The Auto Stand-by function automatically
deactivates the appliance to decrease the energy
consumption when:
• You do not use the appliance for 5 minutes
before you press the Start/Pause button.
Press the On/Off button to activate the
appliance again.
• After 5 minutes from the end of the washing
programme.
Press the On/Off button to activate the
appliance again.
The display shows the end of the last set
programme.
Turn the programme knob to set a new cycle.
If you set a programme or an
option that ends with water in the
drum, the Auto Stand-by does not
deactivate the appliance in order
to remind you to drain the water.
is on. The door
goes off, you can open
Washer Dryer User Manual