Table of Contents
Advertisement
Plastic Tools
Use with
Contact
MS Part
Size
Number
M81969/
(Green)/
22D
14-01*
*Double end insertion/removal tool.
NOTE
Non-Garmin part numbers shown are not maintained by Garmin and consequently are
subject to change without notice.
3.3 Backshell Assembly
The GRA 5500 connector kit includes a circular strain relief assembly. The circular strain relief gives the
installer the ability to quickly and easily terminate shields. In non-Garmin Integrated Flight Deck (retrofit)
installations, the Garmin circular configuration module may also be attached to the strain relief (see
Figure
B-2). Refer to the document Circular Connector (and Configuration Module) Installation
Instructions (190-00313-12) for circular connector installation.
3.4 Antenna Installation
Refer to
Section 2.3.4
for installation instructions.
3.5 Unit Installation
For final installation and assembly, refer to the outline and installation drawings shown in
this manual and to the following procedures.
3.5.1
Installation Procedure (see Figure 3-1)
1. Place the unit on the mounting rack, ensuring the GRA 5500 rear feet are aligned in the mounting
rack slots.
2. Slide the GRA 5500 back until the feet are fully engaged with the mounting rack.
3. Lift the lockdown mechanism collar in place on the GRA 5500 hook and hand turn the lockdown
mechanism knob clockwise until the GRA 5500 is secure and the knob cannot reasonably be
ratcheted any tighter by hand.
3.5.2 Removal Procedure (see Figure 3-1)
1. Pull back on the lockdown mechanism and simultaneously turn counterclockwise until free.
GRA 5500 Installation Manual
Page 3-2
Table 3-4 Recommended Removal Tools
For Unwired
Contacts
Color
Proprietary
Part Number
11-10050-07
White
Metal Tools
Angle Type
Proprietary
MS Part
Part
Number
Number
M81969/8-02
11-8675-24
Straight
Type
Proprietary
Color
Part
Number
Green/
11/8795-24
White
Appendix B
of
190-01277-00
Rev. A
Advertisement
Table of Contents
