Table of Contents
Advertisement
2 INSTALLATION OVERVIEW
2.1 Introduction
This section provides hardware equipment information for installing the GRA 5500, related hardware, and
antennas. Installation of the GRA 5500 must follow the aircraft TC or STC requirements. Cabling is
fabricated by the installing agency to fit each particular aircraft. The guidance of FAA advisory circulars
AC 43.13-1B and AC 43.13-2B, where applicable, may be found useful for making retrofit installations
that comply with FAA regulations.
Refer to
Appendix B
for rack drawings and dimensions.
2.2 Installation Materials
The GRA 5500 is only available as a single unit under the following part number:
GRA 5500, Unit Only (011-02537-00)
2.2.1
Available Equipment
Each of the following accessories are provided separately from the GRA 5500 and are required for
installation.
Sub-Assy, GRA 5500 Mounting Rack
Sub-Assy, Connector Kit, GRA 5500 (For Garmin Integrated
Flight Deck installations)*
Sub-Assy, Connector Kit w/Config Module & USB Pigtail,
GRA 5500 (For retrofit/stand-alone installations)*
*Each GRA 5500 connector kit provides seal plugs for the circular connector. Refer to the Circular
Connector (and Configuration Module) Installation Instructions (GPN: 190-00313-12) for seal plug,
config module, and connector installation instructions.
190-01277-00
Rev. A
Table 2-1 Available Units
Item
Table 2-2 Available Equipment
Item
Garmin P/N
010-00946-00
Garmin P/N
011-02567-00
011-02573-00
011-02573-01
GRA 5500 Installation Manual
Page 2-1
Advertisement
Table of Contents
