Wireless Charging Hub Button - Covidien Kangaroo Operator's Manual

Section 12 — Maintenance
For general maintenance issues not discussed below, contact Customer Service.
Warning: Do not open the main housing on the pump, WCH or WiFi module, as
there are no user-serviceable parts inside. Opening of device may affect function
of the device and voids the warranty.
The following maintenance items/parts can be replaced by the customer on
the pump and WCH. See Section 13 for Service Part Numbers and Section 11 for
contacting Customer Service.

Wireless Charging Hub Button

If damaged, the Kangaroo connect WCH button can be replaced. Important
Note: It is not necessary to remove any screws from the WCH to replace
the Button!
1. Carefully remove the damaged button and spring from the front recess of
the WCH.
2. Obtain Kangaroo connect WCH replacement button from Covidien using
the order code in this manual.
3. Lay the WCH on its back. Insert the replacement spring inside the button
cavity in the front of the WCH. There is a retention feature inside to help hold
it in place.
4. Insert the pointed tip of the replacement button into the hole in the front of
the WCH.
5. Rotate the replacement button until the button face is nearly parallel with
the front of the base.
6. Press on the button face until the button snaps into the hole. The
replacement button should now be fully retained.
Power Adapter
See Section 5 for initial setup, including the power adapter attachment. The
power adapter can be used interchangeably with the pump or the WCH.
Pole Clamp
See Section 5 for initial setup, including attachment of the pole clamp to the
pump and WCH.
Pole Clamp Latch Clip Kit
To replace the pole clamp latch clip on the pump:
Using a Phillips head screwdriver, remove the two small screws that hold the
clip into place. Remove the old parts and discard according to local disposal
regulations. Purchase a Covidien Kangaroo Connect pole clamp latch clip kit.
Take the new clip and place over the two brass inserts in the pump's clip pocket.
Use the new screws from the kit to screw the new clip in place. Do not over
tighten the screws.
Cassette Latch Clip Kit
To replace the cassette latch clip from the pump:
Using a Phillips head screwdriver, remove the two small screws that hold the
clip into place. Remove the old parts and discard according to local disposal
regulations. Purchase a Covidien Kangaroo cassette latch clip kit. Take the new
clip and place over the two brass inserts in the pump's clip pocket. Use the new
screws from the retention plate kit to screw the new clip in place. Do not over
tighten the screws.
Table of Contents
Kangaroo™ Connect Enteral Feeding Pump | 25