Safety Information - JEM Glaciator X-stream User Manual

• LED displays for FOG and ICE controls
• Fog and density controls for easy set-up
• Timer functions
• Two-speed condenser fans enable reduced noise operation
S A F E T Y I N F O R M A T I O N
Warning! This product is not for household use. It presents risks of
lethal or severe injury due to electric shock, burns, falls and
breathing problems.
Read this manual before powering or installing the device, follow the
safety precautions listed below and observe all warnings in this manual
and printed on the device (yellow labels). If you have questions about how
to operate the device safely, please contact a Jem distributor for
assistance or call the Martin 24-hour service hotline at +45 70 200 201.
Refer any service operation not described in this manual to a qualified
technician.
Preventing electric shocks
• Always ground (earth) the device electrically.
• Use only a source of AC power that complies with local building and
electrical codes, and that has both overload and ground-fault
protection.
• Check the voltage is correct for use with the fixture. The voltage setting
is printed on the serial label.
• Disconnect the device from AC power before refilling the fluid tank or
servicing, and when not in use.
• This machine is not waterproof, and should not be exposed to wet
outdoor conditions.
• Do not spill fluid over the machine. If fluid is spilled, clean the fixture
with a damp cloth. If fluid is spilled onto electronic parts, contact an
approved Jem dealer for advice.
• Do not remove the covers or attempt to repair a faulty machine.
• Refer all service to an authorized JEM dealer.
• Never operate the device with damaged or missing parts.
Introduction 5