Producing Timed Output - JEM Glaciator X-stream User Manual

2 Set the Standby switch to ON. The Fog display should show 'FOG/Ht' and
the Ice display should show 'Den/nor'.
3 Set the Ice switch to ON.
4 Set the Fog output to the appropriate level by pressing the menu key on
the left display once, and then adjusting the output level using the
up/down keys. Press Enter to store the value (so that it will be the stored
for the next time the fixture is used).
Note: If you are starting the machine for the first time or after the
fluid has been changed, the pump may need to be primed. Do
this by setting the fog output to 20 (100% output) and firing
the machine for 10 seconds or until fog is produced at the
output. The unit may not prime properly if the ice system is
not at -15 degrees Celsius (5 degrees Fahrenheit) or below
because the ramping system is on and not allowing for 100%
output. The ramping system can be overcome by switching the
ICE switch to off, and then priming the pump.
When the machine is ready, after approximately 8 minutes heat-up time,
fog can be produced. The machine should be left for at least another 22
minutes to allow for best results.
5 Set the Fog switch to ON to produce continuous output of Heavy Fog. The
Fog display should show 'Fog/14' and the Ice display should shows
'Den/nor'.
To check the status of the refrigeration system at any time, use the ICE
menu on the right hand display panel. The left hand panel will display the
name of the value, while the right hand display will show the temperature.
Use the scroll keys on the right hand display to move through the available
values.
P R O D U C I N G T I M E D O U T P U T
To produce timed output:
1 Configure the 'ton' and 'toF' menus on the left display, setting the on and
off periods.
2 Set the Timer switch to ON. The Fog display should show ton/04, toF/03
and the Ice display should show 'Den/nor'.
Note: The Fog switch overrides the timer switch.
30 Glaciator X-Stream user manual