Related Manuals for JEM ZR12-AL
Summary of Contents for JEM ZR12-AL
- Page 1 USER GUIDE VERSION 1.4 ZR12-AL ZR12-AL MANUFACTURED BY MARTIN MANUFACTURING (UK) PLC BELVOIR WAY, FAIRFIELD INDUSTRIAL ESTATE, LOUTH, LINCOLNSHIRE. LN11 0LQ. TEL:(01507) 604399 FAX:(01507) 601956 MARTIN MANUFACTURING (UK) PLC...
- Page 2 Super Note: The JEM warranty will be void if any fluid other then JEM approved fluid is used. If other fluids are used there could be serious damage to the machine and the fluid may not of been tested for use in public areas.
- Page 3 • Getting Started • Using The Remote Control • Using The Analogue Link • The ZR12-AL Ducting Kit • Trouble Shooting • How To Contact Us Note: Martin Manufacturing (UK) reserves the right to modify or change the specification of this product without prior notice.
- Page 4 Notes Introduction The ZR12 is the first small JEM machine to feature the new “AL” Analogue Link technology. This allows units to be linked together and controlled from one JEM Multi Function Controller. The ZR12 is also fitted with a 1 kW heat exchanger which guarantees the maximum output from this size of vaporizing system.
-
Page 5: Troubleshooting
ZR12-AL USER GUIDE Trouble Shooting Safety • Always use a JEM approved fluid, other fluids could be dangerous and could cause damage to the machine. • Always check the voltage is correct for use with the machine, the voltage setting is printed on the serial label. -
Page 6: Machine Layout
The JEM ZR12-AL ducting kit enables the user to duct the smoke from the machine to an area where the effect is required. This is done by using the JEM ducting adaptor and a length of 100 mm (4“) ducting pipe. The length can be Fluid compartment anything from a couple of metres up to 20 metres or further. -
Page 7: Getting Started
ZR12-AL USER GUIDE ZR12-AL USER GUIDE Using The Analogue Link Getting Started • ZR12-AL has the ability to connect machines together using a Din lead Once you have selected the best position for the ZR12-AL you can begin to and then operating all of the machines with one controller. This is ideal when use the machine. -
Page 8: Using The Remote Control
The x8 timer value gives even greater flexibility when a longer An extension lead is available from JEM for using the controller out of delay and run time are needed.
Need help?
Do you have a question about the ZR12-AL and is the answer not in the manual?
Questions and answers