JEM Glaciator X-stream User Manual page 14

devices have 5-pin connectors and others may have reversed signal
polarity, that is, pin 2 hot and pin 3 cold.
5-pin to 3-pin
Male
P/N 11820005
C o n n e c t i n g t h e d a t a l i n k
1 Connect a data cable to the controller's output. If controller has a 5-pin
output, use a 5-pin male to 3-pin female adaptor (P/N 11820005).
2 Lead the data cable from the controller to the first fixture. Plug the cable
into the fixture's data input.
3 Connect the output of the fixture closest to the controller to the input of the
next fixture. If connecting two fixtures with opposing polarity on pins 2 and
3, insert a phase-reversing cable between the two fixtures.
4 Continue connecting fixtures output to input. Up to 32 devices may be
connected on a serial link.
5 Terminate the link by inserting a male termination plug (P/N 91613017)
into the data output of the last fixture. A termination plug is simply an XLR
connector with a 120 ohm, 0.25 W resistor soldered across pins 2 and 3.
14
Adaptor
Female
1 1
2 2
3 3
4
5
Male
Termination Plug
Male XLR
1
2
120
3
P/N 91613017
Glaciator X-Stream user manual
3-pin to 5-pin
Adaptor
Male Female
1 1
2 2
3 3
4
5
P/N 11820004
Female
Termination Plug
Female XLR
1
2
120
3
P/N 91613018
3-pin to 3-pin
Phase-Reversing
Adaptor
Male Female
1 1
2 2
3 3
P/N 11820006