ACONLABS On Call Vivid User Manual page 18

press the Power button to go to the Test Reminder set up.
Note: The meter allows the hypoglycemia level to be as high as 100 mg/dL.
The hypoglycemia level should be below the hyperglycemia level. Consult your
doctor before determining what your hypo blood glucose level is.
10. Test Reminder: Test reminders are a useful way to remind you when to test.
You can set 1 to 5 reminders per day. Your meter is preset with the test
reminder disabled. You must turn it on to use this feature.
•
Press the M or S button to turn the first Test Reminder "On" or "Off". Press
the Power button to confirm your selection. When the Test Reminder is
"Off", pressing the Power button will go to the set up of the second Test
Reminder. When the Test Reminder is "On", pressing the Power button will
go to the set up of the time for the first Test Reminder. Press the M or S
button to adjust the first Test Reminder time.
Press the Power button to confirm the first Test Reminder time and then go
to the second Test Reminder set up.
•
When the Test Reminder is "Off" during the second Test Reminder set up,
pressing the Power button will go to the set up of the third Test Reminder.
When the Test Reminder is "On", pressing the Power button will go to the set
up of the time for the second Test Reminder. Press the M or S button to
adjust the second Test Reminder time. Press the Power button to confirm the
second Test Reminder time and then go to the third Test Reminder set up.
•
Repeat the same set up procedure for Test Reminder 3, 4 and 5.
•
After finishing the fifth Test Reminder set up, it will then end the setup mode
and power off the meter.
If one or more test reminders have been set, the
reminder symbol will always appear on the LCD screen
when the meter is turned on. The display sample is
shown below.
The meter beeps 5 times when it is first set. It will beep
again two minutes later, and two minutes after that
unless you insert a test strip or press any button. This
function will still work with Audio feature turned off.
When the meter beeps at the time set by the Test
Reminder feature, the date, time and strip symbol will
be displayed. The Test Reminder symbol will also flash.
The display sample is shown below.
16