Service Data; Installation; Technical Data - Zanussi ZCV69350BA User Manual

Problem
The lamp does not operate.
The display shows "12.00".
Steam and condensation settle
on the food and in the cavity of
the oven.
There is no good cooking per-
formance using the Plus Steam
function.
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.

SERVICE DATA

If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

INSTALLATION

WARNING! Refer to Safety chapters.
24
Possible cause
The lamp is defective.
There was a power cut.
You left the dish in the oven for
too long.
You did not fill the cavity em-
bossment with water.
The temperature is too low.
There is to much water in the
cavity embossment.
We recommend that you write the data here:
Replace the lamp.
Reset the clock.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Refer to "Activating the Plus
Steam function".
Set the temperature at least to
110°C. Refer to "Hints and
Tips" chapter.
Deactivate the oven and make
sure that the appliance is cold.
Wipe the water with a cloth or
sponge. Add the correct
amount of water to the cavity
embossment. Refer to "Activat-
ing the Plus Steam function".
the oven cavity. Do not remove the rating plate from
the oven cavity.
.........................................
.........................................
.........................................

TECHNICAL DATA

Dimensions
Height
Width
Remedy
894 - 912 mm
550 mm