Location of the appliance
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
Levelling of the appliance
Use small feet on the bottom of appliance to set
the appliance top surface level with other
894 - 912 mm
Adjust the appliance to the correct height and
put it in the correct area before you attach the
Install the anti-tilt protection to
prevent the appliance from falling
under incorrect loads. The anti-tilt
protection only works when the
appliance is put in a correct area.
The anti-tilt protection has two parts (A + B).
You can find the anti-tilt protection (B) on the
right or left side of the rear wall of the appliance.
1. Install the anti-tilt protection (A) on the wall.
Make sure that the wall is made of a solid
material. If not, you need to make the wall
sufficiently strong to hold the weight.
Make sure that the surface behind the
appliance is smooth.
2. Put the appliance in the middle of the space
between the cupboards.
If the space is larger than the width of the
appliance, you must adjust the side
3. Install the anti-tilt protection (A)
approximately 77 mm below the top surface
of the appliance and 50 mm from the left or
right side of the appliance into the circular
hole on the bracket. Screw it into the wall.
4. Check that the anti-tilt protection (A) fits
minimum 20 mm into the hole in the rear
wall of the appliance (B) when you push the