CMA Dishmachines UC65e Quick Setup Instructions
Hide thumbs
Also See for UC65e:
- Service replacement parts (34 pages) ,
- Installation & operation manual (68 pages) ,
- Quick setup instructions (2 pages)
Advertisement
Quick Links
UC65e
Quick Setup
Instructions
WARNING: Electrical and
plumbing connections need
to be made by a qualified
service person who will
comply with all available
Federal, State and Local
Health, Electrical, Plumbing
and Safety codes.
STEP
1
NEUTRAL
LINE 1
LINE 2
115/208/230V
Connect lines 1 and 2 to electrical block located
inside front panel.
STEP
2
1"AIR GAP
WALL DRAIN
Connect the drain hose to wall or floor drain. The
floor drain must have a 1 inch air gap between
drain hose and floor drain.
PN: 10130.29
GROUND
STEP
3
FLOOR DRAIN
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back to
ensure proper performance.
ELECTRICAL CONNECTIONS
LOCATED INSIDE FRONT
PANEL
3/4" DRAIN
OUTLET
LEVELING
LEGS
1/2" WATER
INLET
ELECTRICAL
INLET
STEP
4
Connect dishmachine to hot water source, minimum
temperature 120F, better results at 140F.
1
2
3
4
11-2016
Advertisement
Related Manuals for CMA Dishmachines UC65e
Summary of Contents for CMA Dishmachines UC65e
- Page 1 UC65e Quick Setup Instructions WARNING: Electrical and plumbing connections need to be made by a qualified service person who will comply with all available Federal, State and Local Health, Electrical, Plumbing and Safety codes. ELECTRICAL CONNECTIONS LOCATED INSIDE FRONT PANEL 3/4"...
- Page 2 DETERGENT and Safety codes. RINSE/PRIME NOTE: To prevent Heating Element OVERFLOW TUBE damage, the UC65e heater must be filled with water before the heating element is energized. For this reason RINSE TEMP the High Liimit Switch has intentionally been disconnected...
Need help?
Do you have a question about the UC65e and is the answer not in the manual?
Questions and answers