Inv On/Stand By Button Response Time Setting; Ring Signal Start Setting; Battery Starting Frequency Setting - Sanyo Denki Sanups ASE-H series Instruction Manual

◆ 12.2.6 INV ON/STAND BY Button Response Time Setting
Sets the response time of the INV ON/STAND BY button when the UPS Unit is set to
the STANDBY state.
Setting item Item LED indication
INV ON/STAND BY
button response
time
Caution
After changing the setting, turn off the
least one minute to shut down the inverter, and then restart (changes do not take
effect until after restarting).
◆ 12.2.7 Ring Signal Start Setting
Sets Ring signal start capability. When a Ring signal is enabled, the PC can be
started when the UPS system starts up.
Setting item Item LED indication
Ring Signal Start
Caution
This setting is effective only with PCs that support the Wake On Ring feature, and it
must also be enabled in the settings on the PC.
After changing the setting, turn off the UNIT SW on Stand By operation for at
least one minute to shut down the inverter, and then restart (changes do not take
effect until after restarting).
◆ 12.2.8 Battery Starting Frequency Setting
Sets the AC output frequency when starting under battery power.
Setting item Item LED indication
Battery starting
frequency
Caution
After changing the setting, turn off the
one minute to shut down the inverter, and then restart (changes do not take effect
until after restarting).
Setting value
1 second*
○ ● ● ○
3 seconds
UNIT SW on Stand By operation for at
Setting value
● ● ● ○ Enabled*
Disabled
Setting value
○ ○ ○ ●
UNIT SW
- 34 -
Setting value LED
Setting value LED
indication
Setting value LED
indication
50 Hz*
60 Hz
on Stand By operation for at least
indication
● ○
○ ●
● ○
○ ●
● ○
○ ●