Back To The Housebody; Porch Assembly - Real Good Toys Special Edition Alison, Jr. Instructions Manual

Instructions for the Special Edition #SE-JM907 The Alison, Jr.

Back to the Housebody...


20. Glue and tape the Tower Front in place fl ush
along the edges (Illustration #15).

21. Glue and tape the Top Tower Sides to the Tower
Front, lined up at the top (Illustration #16).
Flush

Porch Assembly:

The parts used in this section should be painted
ahead of time. If they have not been painted, do so now.
Preview: In this section, you will assemble the Porch.
Lay the housebody on its back. Place two Dividers on
the Right Front Panel, one touching the porch base, and
one touching the bottom of the Top Floor.

22. Glue the Porch Mid Floor to the Front Panel and
the Right Tower Side in the space between the Dividers.
Use Blind Dividers to stabilize the Porch Mid Floor in
position! (Illustration #17).
3
[the Porch Mid Floor is

9
23. Glue (2) / " Trim - 9" to the right side of the
16
Tower, lined up in Front.
Illustration #16
Tower
Top
Side
/ " thick]
8
Illustration #15
Tower Front
Flush
Illustration #17
9
/ " Trim - 9"
16
Temporary use of Dividers and Blind Dividers to
hold the Porch Floors while the glue sets. Remove
the Dividers before installing the Porch Gingerbread
C: Foundation, D: Porch
Flush
Divider
Divider
Porch Mid Floor
Page 12
Blind Divider