Brackets; Tower Roof - Real Good Toys Special Edition Alison, Jr. Instructions Manual

Instructions for the Special Edition #SE-JM907 The Alison, Jr.

Brackets:

32. Paint the Brackets before attaching them.
Turn the house upside-down.
Lay out the Brackets as follows:
• Three pairs across the Tower Front
(Illustration #26)
• Four pairs on each Side of the house (Illutrtation .#27)
The outside pairs touch the Trimstrips. Space the Brack-
1
ets in each pair about /
16
9
is right (about 3 / " on the sides and 3
16
remove the Brackets one at a time, and glue that bracket on..
etc. until all the brackets are glued on. Check that all the
spacing is still the way you like it. Let the glue dry.

Tower Roof:

33. A. On the outside of the Tower Roofs, draw guide-
lines for locating Shingles. The fi rst guideline should be
drawn one Shingle length from the bottom edge. Draw the
rest of the guidelines spaced 1" apart
(Guideline Measure on page 15).
B. Glue and tape the Tower Roofs together with the
Tower Front Roof overlapping the Tower Side Roofs.
Glue the Tower Roof Top in place on the Tower
Roofs, spaced evenly all around. Tape and weight as neces-
sary for a good fi t. Paint the Tower Roof Top.
C. Glue the Tower Roofs to the house Roof Top,
spaced evenly on the front and sides.
Tower Side
Roof
Tower
Front
Roof
Step 33 B
Tower Roof Top
" apart. When the Bracket spacing
3
/ " on the tower),
16
F: Trim, Tower Roof
Illustration #26
Tower Front
3
3 /
16
Illustration #27
Step 33 A
Tower
shingle
guidelines
Page 17
Brackets
"
Space approx. 1 / "
3
16
on center
1
3 /
16
step 33 C
Spaced
evenly