Real Good Toys Special Edition Alison, Jr. Instructions Manual page 10

Instructions for the Special Edition #SE-JM907 The Alison, Jr.
11. Hold the Tower Floors against the House
Floors and check out the fl ooring pattern. When
it is right, the pattern will be a continuous board
width from the back of the house to the front.
Glue and tape the Tower Floors in place, into the
grooves of the Tower Right Side, and against the
housebody's fl oors (Illustration #8). Make sure
the top surface of the joint is lined up smoothly.
12. Glue and tape the Tower Left Side and
Fillstrips to the Tower Floors.
13. Glue and tape the housebody's Left Front
in place (Illustration #9).
14. Lay the housebody down on its back.
Without glue, test the fi t of the Top Floor
on the housebody, centered side-to-side. The Top
Floor overhangs the Tower Sides
and overhangs the house
Lightly trace the perimeter of the house-
body on the bottom of the Top Floor (Illustration
#10). Check to make sure the housebody's sides
are parallel with the sides of the Top Floor. The
space outside the edges must be
side.
Remove the Top Floor and paint the outside
of the tracing now. Make sure your housebody
painting is done as well. Let the paint dry.
You can skip ahead to the section for assem-
bling the Windows, and come back here when
the paint is dry.
Wiring? Now is the best time to prepare for wiring.
See www.realgoodtoys.help
Illustration #10
bottom of the Top Floor
1
/ " in the front
8
11
/ " on each side.
16
11
/ " on each
16
Trace the Housebody on the
11
/
16
Illustration #8
Illustration #9
Left Front Panel
1
/ " overhang
8
" overhang
B: Housebody
Top Floor
11
/
16
Page 10
" overhang