Table of Contents
Advertisement
Fig. 3-24. Loosen Rotating Knife Screws
Fig. 3-25. Store Knives in a Safe Place
Fig. 3-26. Loosen the Table Handles
Heavy Duty Tab Cutter Issue 1
Step: 3. Loosen the two screws holding the small
rotating knife in the casting and remove
knife by sliding forward. Do not remove
screws, just loosen. Be careful not to
drop bump or nick knife. Do the same
with the large rotating knife (three screws
to loosen).
Step: 4. Store the four knives in a safe place
where they will not be damaged. Before
storing, put thin coat of oil on all pieces.
Step: 5. Install the new set of four knives.
Step: 6. Set the knives as explained above under
heading Procedure Extension.
NOTE!
Remember, after knives are set, work
them all by hand to make sure they do
not bump or rub. Check by cutting a
piece of paper with them by hand.
After this, tilt table down, turn on air
with 3- way valve.
3.4.6
To Change Tab Position on
Sheet
To change the tab position:
Step: 1. Loosen the two handles at front of
machine so that table will slide from right
to left and left to right.
3 Operation
3- -13
Advertisement
Table of Contents
