Setting Tab Cutting Knife Blades 3 - Scott Heavy Duty Tab Cutte Instruction Manual

3 Operation
3.4 Setting Tab Cutting Knife Blades
3.4.1 Upper Knife Blades
Before locking the upper knife blades, be sure that both the blades and the paper stops (located under the
blades) are pushed to the back of the knife holder castings. After the upper blades are locked, set the lower
blades as explained below:
3.4.2 Lower Knife Blades
Caution !
IMPORTANT: THE FOLLOWING PROCEDURE MUST BE FOLLOWED OR YOU WILL
DAMAGE YOUR KNIFE BLADES.
Fig. 3-11. Rotate Upper Blade Down
Fig. 3-12. Loosen Lower Mounting Blade
Screws
3- -8
Set only one blade at a time. The following
instructions apply to both the long and short knife
blades.
Step: 1. Rotate the upper blade down as low as
the machine will permit.
Step: 2. Loosen the lower blade mounting screws.
Heavy Duty Tab Cutter Issue 1