Scott Heavy Duty Tab Cutte Instruction Manual page 21

2 Installation
Note !
There are no other adjustments necessary other than the adjustment of the cutting force
which is done by changing the air pressure.
Fig. 2-5. Connect Air Line
Fig. 2-6. Main Air Regulator Set to 50Lbs.
2- -6
Step: 7. Supply a 1/4 NPT air line with 5 ScFm @
80psi (142LPM @ 5.3bar) to the air shut
off valve located at the back of the
machine.
Note !
The compressed air line at the main
AIR IN features a ON/OFF valve for
safety. Place the valve in the closed
(down) position when connecting the
machine to the plant air supply.
Step: 8. Set the main air regulator to 50psi
(3.4bar). (60lbs is recommend pressure
to use).
Note !
Unit will not operate properly at less
than 50lbs. pressure.
Step: 9. Plug electrical cord plug into a 110 volt
power source.
Heavy Duty Tab Cutter Issue 1