Table of Contents
Advertisement
3 Operation
Fig. 3-21. Move to Size, Tighten Mounting
Screws
Fig. 3-22. Loosen Stationary Knife Screws
Fig. 3-23. Slide the Knife Out of the Key Slot
3- -12
Step: 3. Slide the small rotating knife casting to
the position desired. The small side
should be approximately level with the
long side.
Step: 4. Tighten mounting screws.
Step: 5. See 3.4 Procedure for Setting Tab
Cutting Knife Blades.
!
CAUTION
MAKE SURE YOU HAVE
TIGHTENED SCREWS ON BOTH
KNIVES SECURELY AND NEVER
WORK THE MACHINE
AUTOMATICALLY UNTIL YOU
HAVE DONE IT BY HAND TO
CHECK YOUR SETTING.
Step: 6. Tilt table top down tighten pinch lock
handles, turn on air pressure with ball
valve at lubricator assembly, the machine
is ready for tab cutting.
3.4.5
To Change Knives for New Tab
Extension
To change the tab extension, it is necessary to
remove all four knives and replace with a new set
of four. This is easily done as follows:
Step: 1. Loosen the two screws holding the short
stationary knife. Do not remove screws,
just loosen.
Step: 2. Slide lower knife out of its key slots.
Leave the screws and nuts attached for
quick changing the next time you use
knife. Be very careful not to bump, drop
or nick knife. Do the same with the large
stationary knife (three screws to loosen).
Heavy Duty Tab Cutter Issue 1
Advertisement
Table of Contents
