Care And Adjustment Of Tab Cutting Knives - Scott Heavy Duty Tab Cutte Instruction Manual

3.3

Care and Adjustment of Tab Cutting Knives

The Scott tab cutting knives are made of the finest tool steel, hardened and ground. With proper care they
will last indefinitely and will seldom require sharpening.
All personnel should be instructed to handle them with proper care.
They should not be dropped since hardened tool steel will break. They should not be bumped against other
hard surfaces or against themselves since they will nick. Your tab cutting knives are expensive valuable tools
and should be treated as such. When not in use, cover the knives with a thin coat of oil and store in a safe
place.
Fig. 3-8. Turn Off Air, Mode Switch to OFF
Fig. 3-9. Loosen Pinch Lock Handles
Fig. 3-10. Tilt Table Forward
Heavy Duty Tab Cutter Issue 1
3.3.1 Before Adjusting Tab Cutting
Knives:
Before adjusting your tab cutting knives always do
the following:
Step: 1. Shut off Main Air by sliding quick
disconnect down. This allows you to work
the knives up and down by hand and is
is a safety precaution.
Step: 2. Set Mode Switch to OFF.
Step: 3. Loosen the two pinch lock handles at
front under table.
Step: 4. Tilt the table up.
It will not be possible to adjust the
stationary knives unless the table is in
this position. By tilting the table, the
electricity is disconnected and the knives
will not accidently move.
3 Operation
3- -7