SATO M-5900RV Operator And Technical Reference Manual page 164

Section 4. Programming Reference
Custom Protocol Command Codes
Printer Output (Cont)
Special Notes
1. Commas must be used to separate the parameters. If a parameter is omitted
between two commas, the default Non-Standard Protocol Command codes for
that parameter will be used. See Appendix E.
2. This command must be sent as an independent data stream immediately
following the <ESC>A Start code and immediately preceding the <ESC>Z Stop
code. No other commands can be included in the data stream.
3. If more or less than nine commas are included in the command, the entire
command sequence will be ignored. The command must contain exactly nine
commas.
4. If two characters are specified for a parameter, it will be interpreted as a hex
value. For example:
If a combination of characters are outside the hexadecimal range, the entire
command sequence will be ignored.
5. Downloading Auto Online and Zero Slash settings will overwrite the values
selected using the LCD panel. If these settings are changed using the LCD
panel, they will overwrite any previously downloaded settings.
Page 4-98
Download
STX = 7B ETX = 7D
ENQ = 23 CAN = 26
OFFLINE = 7E
AUTO ONLINE =
ZERO SLASH =
Press the "FEED" key to activate
the User Default or power the
printer off to ignore them.
Command Parameter
2B
+
SATO M-5900RV Operator and Technical Reference Manual
ESC = 25
NULL = 2A
YES
YES
Resulting Command Code
+
+
PN 9001081
Rev. C