SATO M-5900RV Operator And Technical Reference Manual page 100

Section 4. Programming Reference
Special Notes
1. Use the Print Position commands (V and H) to locate the new area for the duplicate
image (see Page 4-61).
2. Position of the new target area must not be inside the original image.
3. If you use the Rotate command, V, H, X and Y axis will be reversed.
4. If the reference area of the target image exceeds the print area, it will not be printed.
5. The allowable field ranges for these fields are as follows:
Page 4-34
H o i r o z n l a t
a a a a
c c c c
V r e c i t l a
b b b b
d d d d
SATO M-5900RV Operator and Technical Reference Manual
M 5 - 9 0 0 R V
0 0 0 1
0 0 0 1
o t 0 8 9 6
o t 1 4 2 4
PN 9001081
Rev. C