Job Id Store - SATO M-5900RV Operator And Technical Reference Manual

Section 4. Programming Reference
Command Structure
<ESC>IDaa
aa = Job ID assigned (01 to 99)
Example:
Placement:
Default:
Command Function
To add an identification number to a job. The status of the job can then be
determined using the ENQ command in the BI-Com status mode (See Section 5:
Interface Specification for more information).
Printer Input
<ESC>A
<ESC>ID02
...Job...
<ESC>Z
Printer Output
There is not printer output as a result of this command.
Special Notes
1. Works only in Bi-Com mode. The Job ID number must be stored before Bi-
Com status mode can be used.
2. If more than one ID number is sent in a single job, i.e.
<ESC>A
<ESC>ID01
...................
<ESC>ID02
...................
the last number transmitted will be used.
Page 4-48

Job ID Store

<ESC> ID09
Immediately following the <ESC>A in the job data stream.
None
SATO M-5900RV Operator and Technical Reference Manual
PN 9001081
Rev. C