Notes On Usage And Storage; Installation Space; Notes When Using The Printer - Epson SC-T5400 Series User Manual

SC-T5400 Series/SC-T3400 Series/SC-T3400N Series
Notes on Usage and
Storage

Installation space

Make sure that you secure the following space, clear of
any other objects, so that paper ejection and
consumable replacement are not obstructed.
See the "Specifications Table" for the external
dimensions of the printer.
"Specifications Table" on page 185
U
SC-T5400 Series/SC-T3400 Series
W
SC-T5400 1535 mm
Series
SC-T3400 1230 mm
Series
SC-T3400N Series
User's Guide
Introduction
D H
1350 mm 1210 mm
1350 mm 1210 mm
W
SC-T3400N 1230 mm
Series

Notes when using the printer

Note the following points when using this printer to
avoid breakdowns, malfunctions, and print quality
decline.
❏ When using the printer, observe the operating
temperature and humidity range described in the
"Specifications Table".
"Specifications Table" on page 185
U
Even when the conditions above are met, you may
not be able to print properly if the environmental
conditions are not suitable for the paper. Be sure
to use the printer in an environment where the
paper's requirements are met. For more details,
see the documentation supplied with the paper.
Also, when operating in dry areas, air conditioned
environment, or under direct sunlight, maintain
the appropriate humidity.
❏ Do not install the printer next to heat sources or
directly in the path of air from a ventilator or air
conditioner. Failure to observe this precaution
could result in the print head nozzles drying and
clogging.
❏ The print head may not be capped (i.e., may not
move to the right-hand side) if an error occurs
and the printer is turned off without first resolving
the error. Capping is a function for automatically
covering the print head with a cap (lid) to prevent
the print head from drying out. In this case, turn
on the power and wait a while until capping is
performed automatically.
❏ When the power is on, do not remove the power
plug or cut the power at the breaker. The print
head may not be capped properly. In this case,
turn on the power and wait a while until capping
is performed automatically.
❏ The printer may automatically perform print head
cleaning to maintain good printing quality. Please
wait until cleaning finishes without opening any of
the covers or turning off the power.
17
D H
1288 mm 735 mm