Cleaning And Maintenance; Maintenance - Proactive thera3+ Instruction Manual

MASSAGE PROGRAMS (PRESET ONLY) - CONTINUED
Note: Treatment length for all options below is 30 minutes.
Program 3
Phase Pulse Rate
6
7
8
Program 4
Phase Pulse Rate
1
2
Therapy Site Program
3
Shoulder 1 - 2 - 3 - 4
4
Neck 2 - 3 - 4
5
Back 1 - 2 - 3
6
Elbow 2 - 3
Hip 1 - 2 - 3 - 4 7
Ankle 3 - 4
8
Foot 3 - 4
9
Wrist 2 - 3
10
1 - 2
Knee
11

CLEANING AND MAINTENANCE

1. Stimulator
Wipe the stimulator with a soft, slightly moistened cloth. If a more
thorough cleaning is needed, you can also moisten the cloth with
mild soapy water. Do not use any chemical cleaners or abrasive
agents to clean this device.
(Continued)
Pulse Width Work Time
(Hz) ( s) µ (s)
118 50 ~220 2.6
100 50~220 2.8
111 50 ~220 3.3
Pulse Width Work Time
(Hz) ( s) µ (s)
147 30 ~220~ 150 12.0
169 30 ~220~ 150 10.3
196 30 ~220~ 150 8.5
237 30 ~220~ 150 6.8
258 30 ~220~ 150 5.1
290 30 ~220~ 150 5.7
238 30 ~220~ 150 6.3
197 30 ~220~ 150 8
191 30 ~220~ 150 8.5
168 30 ~220~ 150 9.1
150 30 ~220~ 150 10.8
18
2. Electrodes
• Use the device only with the lead wires and electrodes provided
or sold under the ProActive brand, following the placements
and settings prescribed by your practitioner.
Rest Time
• It is recommended to use at minimum 4 cm self-adhesive
(s)
electrodes.
0.6
• Inspect your electrodes before every use and replace as needed.
0.7
Reusing electrodes too many times may cause slight skin irritation,
0.8
low adhesion or ineffective stimulation.
• Between uses, store the electrodes in a resealable bag in a cool
dry place. It may be helpful, between applications, to moisten
Rest Time
the adhesive surface with a few drops of water (be careful not to
(s)
over-saturate) and then let them air-dry to help them last longer.
1.0
3. Cleaning the electrode cords
0.9
Clean the electrode cords by wiping them with damp cloth.
0.6
Coating them lightly with talcum powder will reduce tangles
0.6
and help them last longer.
0.4
0.5
0.5
0.6
0.7
0.8
0.9

4. Maintenance

• Do not attempt any repairs to the device or any of its accessories.
Contact us at 1-800-363-2381 for repair information.
• The manufacturer will not be held responsible for the results
of maintenance or repairs by unauthorized persons.
• Check the device before each use for signs of wear and/or
damage. Replace worn items (electrodes, lead wires) as required.
Type BF Applied part.
Reusable, self-adhesive electrodes
19