To Create A Customized Program; Pre-Set Programs - Proactive thera3+ Instruction Manual

Notes:
• The device will return to standby mode when you press
or after 30 seconds of inactivity.
• To clear the memory: Press and hold S for 3 seconds.
The number of records in memory will flash on screen.
To delete, press . To cancel and return to standby, press
10. Turn the device off
Press and hold to turn the device off. When not in treatment, it
shuts off automatically 3 minutes after the last button operation.
11. Low battery indicator
When the indicator flashes, charge the batteries as soon as
possible. However, the device will continue to operate for about
one hour.

TO CREATE A CUSTOMIZED PROGRAM

Turn on the device, select TENS or EMS and press P to select a user
program. Once in U1, press and hold P to enter setting mode. In this
mode, you can set the pulse width from 50 to 350µs, the pulse rate
from 1 to 150 Hz and treatment time from 5 to 90 minutes.
1. Select the parameter
First press CH1- to switch between the parameters to set
(pulse rate, pulse width, and treatment time).
2. Set each parameter
Then press CH2+ and CH2- to adjust. Press
into standby, then use CH1+ and CH2+ to adjust the amplitude of
each channel.
NOTE: to change the parameters, press and hold P again.
to confirm and go
12
PRESET PROGRAMS IN TENS MODE
Note: Treatment length for all options below is 30 minutes.
.
13