1: Throttle Pedal; 2: Foot Brake Pedal; 3: Parking Brake; 4: Shift Lever - Taylor-Dunn TC-30 Operator's Manual

1: Throttle Pedal

The throttle pedal is located on
the floorboard and is intended to
be operated by the drivers right
foot. It controls the speed of the
vehicle and operates similar to the
throttle pedal in an automobile.
Press the pedal to increase speed
and release the pedal to decrease
speed.

2: Foot Brake Pedal

The foot brake pedal is located to
the left of the throttle pedal. This
pedal is designed for operation with
the drivers right foot. It works similar to the brake in an automobile. Applying pressure to the brake
pedal slows the vehicle according to the amount of pressure applied. Relieving pressure from the
pedal releases the braking action.

3: Parking Brake

The parking brake is actuated with a hand lever, which is located to the right of the driver. To set
the parking brake, Pull the lever up and back until it locks. To release the park brake, Push the
brake lever all of the way down.
Note: The parking brake can be adjusted by rotating the knob on the end of the handle.

4: Shift Lever

Details regarding the shift lever can be found on the following pages.

Directional Signals

Directional signals are optional and may not be
installed on your vehicle.
The turn signal lever is located on the left side of the
steering column. Push the lever forward to activate
the right turn signal and pull the lever back to activate
the left turn signal.
Note: The switch is not self canceling and must be
manual turned off.

Hazard Light Switch

Hazard lights are optional and may not be installed on your vehicle.
The hazard light switch is located on the left side of the steering column. The switch is a small tab.
To activate the hazard lights, pull the tab out. To turn the hazard lights off, push forward or pull back
the directional signal lever.
Page 20
MT-030-60-E
Tiger TC-3060 Operator Manual