Glossary Of Terms - Taylor-Dunn TC-30 Operator's Manual

GLOSSARY OF TERMS

There are a number of words and phrases used in this document that may have a different, special,
or specific definition when use in the context of this document.
A p p r o v e d O p e r a t o r
Position
Caution (signal word)
Danger (signal word)
DBP
Draw bar pull
Electrolyte
LPG
Moderate injury
Notice (signal word)
OPS
Seating position:
Service Brake
Severe bodily injury
Signal word
Small children
Warning (signal word):
Page 8
The operator shall be seated in the operator seat with back up against
the operator seat back cushion. Additional back support may be added
as needed. The back support shall be fastened to the operator seat
back cushion to prevent it from falling off the vehicle or onto the seat
cushion. The operator's left foot shall be on the floorboard. The right
foot should be positioned for easy access to the brake or throttle
pedals. Both hands should be on the steering wheel while the vehicle
is in motion.
Refer to Signal Words and Their Definitions.
Refer to Signal Words and Their Definitions.
Draw Bar Pull (see below).
The force seen by the trailer hitch at the rear of the vehicle.
The fluid inside of a battery.
Liquefied Petroleum Gas, a fuel
An injury treatable by first aid and/or follow up treatment by a doctor
or other professional medical personnel.
Refer to Signal Words and Their Definitions.
"Operator Protective Structure": Steel cab or cage around the
occupants.
When used in the context of occupant seating positions, "seat" is
defined as a single seat cushion or a span of 20 inches on a bench
seat.
The primary braking system used to stop the vehicle.
An injury that requires immediate treatment by a doctor or other
professional medical personnel. Not first aid.
A word used to define hazards to operator, passengers, service
technician, or personnel in the immediate vicinity of the vehicle.
Children that must be transported in a child seat as defined by federal
or state motor vehicle standards.
Refer to Signal Words and Their Definitions.
Tiger TC-3060 Operator Manual
MT-030-60-E