Lamp Replacement; Fuse Replacement - Elation IMAGE PRO 300 Owner's Manual

Lamp Replacement

This fixture is fitted with a metal halide lamp which is highly susceptible
to damage if impro[erly handled. Do not touch the bulb of the lamp with
bare fingers(this can cause damages). The lamp contains small quantities
of materials that will be harmful to the envionment, please dispose of the
damaged lamp properly.
To replace the lamp
1. Disconnect the fixture from power and allow the lamp to cool.
2. Loosen the two knurled screws and remove the top cover.
3. Loosen the 2 thump screws from the lamp socket.
4. Gently take the old lamp out.
5. Replace the new lamp and refit the 2 thumb screws.
6. Put in the new lamp securely into the socket. Please note the
protuberance of bulb shall be upward orientation to obtain equal
intensity distribution(see figure).
7. Tighten the 2 thumb screws and reassemble in reverse order.
Remember always replace with the
same type lamp and fuse.

Fuse Replacement

1. Disconnect the fixture from power.
2. With a flat screwdriver wedge the fuse holder out of its housing.
3. Remove the old fuse from the holder and replace with the exact
same type fuse.
4. Replace the fuse holder in to the fuse holder housing.
5. Reconnect main power.
Metal Halide Lamp Warning!
5