Storing Administrator Fingers And Configuring Normal Mode - eKey home series Operating Instructions Manual

Storing administrator fingers and configuring normal mode

You must store 4 administrator fingers. We recommend storing 2 fingers of 2
different people for this purpose.
 You must commission the system devices in order to store administrator fingers.
Step Action
1st
2nd
3rd No action
required.
24│en Configuration of normal mode and usage of the finger scanner with administrator
fingers
Description
Carry out three Finger
Touches on the sensor within
5 s. This will take you to the
admin menu.
Swipe administrator finger 1
over the sensor to store it.
See "Correct operation of the
finger scanner", page 10.
Repeat this step at least
twice. Between each
individual finger swipe, the
finger scanner lights up
orange if the finger storing
process is not complete.
After the first finger has
been swiped once over the
sensor, no more than 10 s
may pass between each
subsequent swipe.
Otherwise, the finger storing
process will be aborted.
The quality of the fingerprint
is acceptable. However, it
may be possible to improve
the quality by swiping the
finger again.
The quality of the fingerprint
is poor or the finger was not
recognized. Swipe the finger
over the sensor again.
-
Display
The left and
right LEDs
alternate
between
flashing
orange/green.
The central LED
lights up
orange.
The central LED
lights up green.
The finger
scanner lights
up red.
- -
- -
The finger
scanner lights
up green