Video Input; Input Source Selection (Direct Operation) - Sanyo PLV-Z1BL Owner's Manual

Video Input

INPUT BUTTON
You can select Video input or Computer input with the INPUT button.
(The input source that is selected last is selected when the projector is
turned on.)
If the projector cannot reproduce proper video source, select correct
input source through menu operation on the next page.
RGB Scart Input
To select RGB Scart 21-pin video input through the computer input
terminal, follow the procedures described at the section "Input Source
Selection" on page 31.
AUTO / VIDEO / S-VIDEO / COMPO BUTTON
Press AUTO, VIDEO, S-VIDEO, or COMPO button on the remote
control according to video input.
*It is convenient for you to select the AUTO as the projector
automatically detects incoming video signal, and adjust itself to
optimize its performance.
When selecting the AUTO, the projector automatically
AUTO
detects incoming video signal, and adjusts itself to
optimize its performance. The projector selects
connection in the following order:
1st Y-Pb/Cb-Pr/Cr
2nd S-VIDEO
3rd VIDEO
The Y-Pb/Cb-Pr/Cr has priority over the S-VIDEO. The
S-VIDEO has priority over the VIDEO.
When video input signal is connected to VIDEO, select
VIDEO
the Video.
When video input signal is connected to S-VIDEO, select
S-VIDEO
the S-Video.
When video input signal is connected to Y-Pb/Cb-Pr/Cr,
COMPO
select the COMPO.
24

Input Source Selection (Direct Operation)

WARNING
READY
TEMP.
LAMP
INPUT button
LAMP
REPLACE ON-OFF
Video
Computer
TOP CONTROL
MENU
INPUT
SELECT
INPUT button
REMOTE CONTROL
INPUT
VIDEO
AUTO NO SHOW
VIDEO
KEYSTONE
S-VIDEO
COMPONENT
COMPO
AUTO / VIDEO / S-VIDEO / COMPO button
REMOTE CONTROL
INPUT IMAGE
VIDEO IMAGE
NO SHOW
AUTO 1
VIDEO 2
IMAGE
IMAGE
1
2
3
4