Appendix
When the life of the projection lamp draws to an end, the LAMP
REPLACE indicator lights yellow. When this indicator lights yellow,
replace the projection lamp with a new one promptly.
ALLOW A PROJECTOR TO COOL, FOR AT LEAST 45
MINUTES BEFORE YOU OPEN LAMP COVER. THE
INSIDE OF A PROJECTOR CAN BECOME VERY
HOT.
Follow these steps to replace the lamp assembly.
1
Turn off the projector and disconnect AC plug. Allow the
projector to be cooled for at least 45 minutes.
2
To remove the Lamp cover, remove the screw with a
screwdriver.
3
Remove 2 screws with a screwdriver and pull out the Lamp
assembly by grasping the handle.
4
Replace the Lamp assembly with a new one and tighten the 2
screws back into position. Make sure that the Lamp assembly is
set properly. Replace the Lamp cover and tighten the screw.
5
Connect the AC Power Cord to the projector and turn on the
projector.
6
Reset the Lamp Replace Counter.
Refer to "Lamp Replace Counter" on the next page .
NOTE : Do not reset the Lamp Replace Counter when the
Projection lamp is not replaced.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the
following information to the dealer.
G
Model No. of your projector
G
Replacement Lamp Type No.
44
Lamp Replacement
This indicator lights yellow
when the life of the projection
lamp draws to an end.
Replace the Projection Lamp
with a new one.
CAUTION
FOR CONTINUED SAFETY, REPLACE WITH A LAMP
ASSEMBLY OF THE SAME TYPE.
DO NOT DROP A LAMP ASSEMBLY OR TOUCH A
GLASS BULB! THE GLASS CAN SHATTER AND MAY
CAUSE INJURY.
:
PLV-Z1 / PLV-Z1BL
:
POA-LMP54
(Service Parts No. 610 302 5933)
TOP CONTROL
WARNING
TEMP.
LAMP
REPLACE
MENU
HANDLE
SCREW
RE
READY
LAMP
ON-OFF
INPUT
SELECT
SCREW
LAMP COVER
LAMP
ASSEMBLY
SCREW