Part Names and Functions
Remote Control Batteries Installation
Remove the battery
1
compartment lid.
* When the batteries of the remote control are replaced, the remote
control code automatically returns to the initial code (Code 2)(p43).
To insure safe operation, please observe the following precautions:
G Use (2) AA, UM3 or R06 type alkaline batteries.
G Replace two batteries at the same time.
G Do not use a new battery with a used battery.
G Avoid contact with water or liquid.
G Do not expose the remote control to moisture, or heat.
G Do not drop the remote control.
G If a battery has leaked on the remote control, carefully wipe case clean and install new batteries.
G Risk of explosion if battery is replaced by an incorrect type.
G Dispose of used batteries according to the instructions.
Operating Range
Point the remote control toward the projector (Infrared
Remote Receiver) whenever pressing any button. Maximum
operating range for the remote control is about 16.4' (5m)
and 60° in front of the projector.
14
Slide the batteries
2
into compartment.
Pull up the lid
and remove it.
3
Two AA size batteries
For correct polarity (+ and
–),
be
sure
battery
terminals are in contact
with pins in compartment.
60°
16.4'
(5 m)
Replace the compartment lid.