Computer Input; Input Source Selection 5 - Sanyo PLC-XU75 Owner's Manual

Computer Input

Input Source Selection
Direct Operation
Choose either Computer 1 or Computer  by pressing
the INPUT button on the top control or press the
COMPUTER button on the remote control. Before
using these buttons, correct input source should be
selected through Menu operation as described below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Press the Point
red framed pointer to the Input Menu icon.
2
Press the Point
arrow pointer to either Computer 1 or Computer
, and then press the SELECT button.
3
After the Source Select Menu appeared for
Computer 1, move the pointer to RGB and then
press the SELECT button.
Note:
✔
• When the Input Search function is set On1
or On, the input signal will be searched
automatically (p.46)
• C o m p u t e r  i s n o t d i s p l a y e d w h e n t h e
COMPUTER IN /MONITOR OUT terminal is set
as Monitor out. (p.47)
• Computer  (COMPUTER IN /MONITOR OUT)
can accept only RGB signal.
buttons to move the
7 8
buttons to move the red
ed
Top Control
INPUT button
INPUT button
Remote Control
COMPUTER button
COMPUTER button
✳ See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
Move the pointer (red
arrow) to Computer  and
press the SELECT button.
Computer 1
Computer 2
✳
Video
Computer 1
Computer 2
✳
5
25