Video Input; Input Source Selection (Video, S-Video)35 - Sanyo PLC-XU75 Owner's Manual

Video Input

Input Source Selection (Video, S-Video)
Direct Operation
Choose Video by pressing the INPUT button on the top
control or the VIDEO button on the remote control.
Before using these buttons, correct input source should
be selected through menu operation as described
below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Press the Point
framed pointer to the Input Menu icon.
2
Press the Point
pointer to Video and then press the SELECT button
to display the Source Select Menu.
3
Move the pointer to the source that you want to
select and then press the SELECT button.
W h e n s e l e c t i n g A u t o , t h e p r o j e c t o r
Auto
automatically detects the incoming video
signal, and adjusts itself to optimize its
performance. The projector selects a
connection in the following order:
1. S-Video
2. Video
When video input signal is connected to the
Video
VIDEO jack, select Video.
When video input signal is connected to the
S-Video
S-VIDEO jack, select S-Video.
Note:
✔
• When the Input Search function is set On1 or On2,
the input signal will be searched automatically
(p.46)
• When Monitor out is selected in the Terminal
function (p.47), Computer 2 is not displayed.
buttons to move the red
7 8
buttons to move the red arrow
ed
Top Control
INPUT button
INPUT button
✳ See Note at the bottom of this page.
Remote Control
VIDEO button
Input Menu icon
Input Menu
Move the pointer to
Video and press the
SELECT button.
Video
Source Select Menu (VIDEO)
Move the pointer to the
source that you want
to select and press the
SELECT button.
Video
Computer 1
Computer 2
✳
35