Control Panel - Supermicro SuperWorkstation 5039C-T User Manual

SuperWorkstation 5039C-T User's Manual

Control Panel

JF1 contains header pins for various control panel connections. See the figure below for the
pin locations and definitions of the control panel buttons and LED indicators.
All JF1 wires have been bundled into a single cable to simplify this connection. Make sure
the red wire plugs into pin 1 as marked on the motherboard. The other end connects to the
control panel PCB board.
Power Button
The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both
pins will power on/off the system. This button can also be configured to function as a suspend
button (with a setting in the BIOS - see Chapter 6). To turn off the power when the system
is in suspend mode, press the button for 4 seconds or longer.
Reset Button
The Reset Button connection is located on pins 3 and 4 of JF1. Attach it to a hardware reset
switch on the computer case.
20
(Ground)
Key
Power On LED (Control signal)
HDD LED (Activity signal)
NIC1 LED (Ground)
NIC2 LED (Ground)
OH/Fan Fail LED (Ground)
Power Fail LED (Ground)
(Ground)
(Ground)
2
Figure 4-1. JF1 Control Panel Pins
Power Button
Pin Definitions (JF1)
Pin# Definition
1 Signal
2 Ground
Reset Button
Pin Definitions (JF1)
Pin# Definition
3 Reset
4 Ground
42
19
NMI (Control signal)
Key
(5V standby)
(Vcc)
(Vcc)
(Vcc)
(Vcc)
(Vcc)
Reset Button (Data signal)
Power Button (Data signal)
1