Initial Power Up; Examples For Quick Setupo; Analogue Speed Reference 0-10 V To Ai - Emotron VSB Series Instruction Manual

Emotron VSB Instruction Manual
4.5 In itial P ow er u p
Perform wiring in strict accordance with technical requirements as set forth in Chapter 3 -
Installation and Wiring.
4 .5 .1 E x a m ple s fo r Q u ic k se tu p
The following are examples for Quick setup with wiring and parameter settings. For more
detailed information, see "Chapter 6 Specification of parameters".
4 .5 .1 .1 A n a lo g ue s pe e d re fe re n c e 0 -1 0 V to A I
1. Set Signal switch AI to V see chapter 3.10 Instruction of Signal Switches.
2. Connect analogue reference signal + to AI and - to GND. If manual potentiometer
(10kOhm) is used connect the mid point to AI and ends to +10V and GND. see Fig
4.4.
3. Connect start signals: RunFWD to DigitalIn1 and Run REV to DigitalIn2. If none or both
DigIn1 and DigIn2 are activated = Stop
Fig 4-4 Connect pot. to +10V, GND and AI terminal
Chapter 4 Operation and Run instructions
- 41 -