Roof/Canopy (Accessories) - CIAT Climaciat Instruction Manual

6.5 Roof/canopy (Accessories)

6.5.1 Fitting the roof
A Remove the cover(s) from the raceway.
B Fit the left- and right-hand blanking covers at the top of the end panels using the screws supplied in the installation kit.
C Fit the roof panels in the order shown on the dedicated plan. Affix the panels to the raceway (from inside the raceway) using
the screws provided.
D Fix the panels together using the screws and sealed washers supplied in the mounting kit.
E Finally, fix the panels to the omega profiles, again using screws with sealed washers.
F
Fit the covers on the raceway. Make sure a 15 x 3* gasket is positioned at the ends of these covers (inter-block cover seal).
Affix them using screws with sealed washers.
G
Roof on adjacent blocks: see dedicated mounting plan.
3
Mounting on Inter-panel
the raceway mounting
3
A
Raceway cover
C
Roof panels
2
1
E
Mounting on
omega profile
2
1
Roof panel mounting direction
3 2
Blanking
CTA
cover
Roof panel tightening direction
3
EN - 11
B
Blanking covers
D
Roof
panels
1
Blanking cover
without return
bend
F
2
1
EN