CIAT Climaciat Instruction Manual page 11

ƒ Affix the cleats (2)
4.8 x 40 mm (5) in each block.
Fig. A
1
5
4
ƒ Fit the 15 x 9 gasket on the end partition of one block. To ensure a proper seal between two blocks, position the gasket on
the aluminium profiled edge of one block as close as possible to the inside of the unit (illustrations below).
Single partition block
Gasket
ƒ If the AHU has a control option.
Before the blocks are definitively brought together, the cables must be fed into the lower raceway (frame).
SINGLE FLOW AHU
1. Unwind the cables from the ends (the cables are prewound in the factory)
4. Feed the cables through the upper raceway
5. Route downwards into the unit
supplied in the connection
2
3
Gasket
kit (fig.A) in the dedicated
Single partition block
Gasket
Gasket
DUAL-FLOW AHU
1. Unwind the cables from the ends (the cables are prewound in the factory)
2. Route the cables into the lower frame and to the vertical raceway
3. Place the cables in the raceway
4. Feed the cables through the upper raceway
5. Route downwards into the unit
EN - 9
holes using long screws
2
5
EN