Open Bill Path; Cleaning X-1 - Amrotec X-1 Series Instruction Manual

Open Bill Path

Open top bill path
Open bottom bill path

Cleaning X-1

Cleaning the cover of X-1
Periodically clean X-1 as follows:
Prepare a mixture of a gentle kitchen-use detergent (one that does not contain abrasive powder
or strong chemicals such as acid or alkaline.) Mix with 5 cup water with 1 cup detergent.
Soak the sponge with the mixture of diluted detergent for couple of minutes.
Squeeze excess liquid out from the sponge.
Wipe the cover with the sponge in a circular motion and make sure not to let any excess liquid
drips into the interior of the device.
Wipe the exterior surface of the device to remove the detergent.
Rinse the sponge with clean running water.
Wipe the over with the clean sponge.
Wipe the surface again with a dry, soft lint-free cloth.
Wait for the surface to dry completely and remove any fibers.
Cleaning the bill path of X-1
Open the upper bill path.
Gently wipe it or dust the bill path with a brush or a dry, soft lint-free cloth.
If stains or debris remain, moisten a soft lint-free cloth with water or a 50-50 mixture of
isopropyl alcohol and water that does not contain impurities.
Squeeze out as much of the liquid as you can.
Wipe the bill path and the sensor surface again; do not let any liquid drip into the device.
Repeat 1-5 to clean the lower bill path.
*NOTE:
Avoid spraying cleaner directly on the device, and be sure to dry the bill path before closing it.
DRAFT - HIGHLY CONFIDENTIAL
Maintaining X-1 35