1. Manuals
  2. Brands
  3. Amrotec Manuals
  4. Cash Counter
  5. S-200
  6. Assembly instructions

Amrotec S-200 Assembly Instructions

Floor stand for coin sorters
Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

Drawing:
Upper Side Bar
(2 pcs)
Support Bar
(2 pcs)
Lower Side Bar
(2 pcs)
ASSEMBLY INSTRUCTIONS
FLOOR STAND
S-200 AND S-500 COIN SORTERS
Upper Cross Bar
(2 pcs)
Lower Cross Bar (1pc)
Caster Wheels
(4 pcs)
FOR
Screws
(32 pcs)
Shelf (1 pc)
Shelf Bracket
(2pcs)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S-200 and is the answer not in the manual?

Questions and answers

Related Manuals for Amrotec S-200

Summary of Contents for Amrotec S-200

  • Page 1 ASSEMBLY INSTRUCTIONS FLOOR STAND S-200 AND S-500 COIN SORTERS Drawing: Upper Cross Bar (2 pcs) Upper Side Bar (2 pcs) Shelf (1 pc) Support Bar (2 pcs) Shelf Bracket (2pcs) Lower Cross Bar (1pc) Screws (32 pcs) Lower Side Bar...
  • Page 2 Step 1. Locate the Lower Side Bars (2pcs) and Lower Cross Bar (1pc) as picture #1 and turn them upside down (caster wheels on the top). Attach Lower Cross Bar with Lower Side Bars using Screws, washers, and lock washers (8pcs each).
  • Page 3 Step 3. Locate Upper Cross Bars (2 pcs). Attach Upper Cross Bars to Upper Side Bars using screws, washers, and lock washers (8 pcs of each) as picture # 5. Picture # 5 Notes: When attaching Upper Cross Bars, please make sure that holes are facing up. Also do not tighten all Upper Cross Bar screws until all screws are in place.
  • Page 4 Step 5. Place your coin sorter on the stand securely by following the steps below Locate the 4 holes on the Upper Side Bars as Picture # 8. Locate 4 Pin (metal rod) at the bottom of the coin sorter. Align those 4 Pin (metal Rod) with the holes on the Upper Side cover and fit the coin sorter inside these holes perfectly (Please have 2 persons to perform this task to avoid any injury) Picture # 8...
  • Page 5 Special Note and Disclaimer Notice: The below pictures showed S-200 and S-500 are on the Floor Stand. Please make sure that Floor Stand is placed on Level Floor (Even Floor). If coin-bagging drawers are ordered with these machines, remove all the coin boxes, and replace them with coin bagging drawers.

This manual is also suitable for:

S-500

Table of Contents