Installation Checklist; Maintenance And Use Guidelines; Minimum And Maximum Pressure; Limited Warranty And Return Policy - Air Lift LoadLifter 5000 Series Installation Manual

LoadLifter 5000 Series
 Clearance test — Inflate the air springs to 40-60 PSI (2.8-4.1BAR) and make sure
 Leak test before road test — Inflate the air springs to 40-60 PSI (2.8-4.1BAR) and
 Heat test — Be sure there is sufficient clearance from heat sources, at least 6" (152mm)
 Fastener test — Recheck all bolts for proper torque.
 Road test — The vehicle should be road tested after the preceding tests. Inflate the
 Operating instructions — If professionally installed, the installer should review the

Maintenance and Use Guidelines

CAUTION
CAUTION

Limited Warranty and Return Policy

Air Lift Company provides a limited lifetime warranty to the original purchaser of its load support
products, that the products will be free from defects in workmanship and materials when used
on cars and trucks as specified by Air Lift Company and under normal operating conditions,
subject to the requirements and exclusions set forth in the full Limited Warranty and Return
Policy that is available at www .airliftcompany .com/warranty.
For additional warranty information contact Air Lift Company customer service.
MN-1045

INSTALLATION CHECKLIST

there is at least 1/2" (13mm) clearance from anything that might rub against each
sleeve. Be sure to check the tire, brakes, frame, shock absorbers and brake cables.
check all connections for leaks. All leaks must be eliminated before the vehicle is
road tested.
for air springs and air lines. If a heat shield was included in the kit, install it. If there is no
heat shield, but one is required, call Air Lift customer service at (800) 248-0892.
springs to recommended driving pressures. Drive the vehicle 10 miles (16km) and
recheck for clearance, loose fasteners and air leaks.
operating instructions with the owner. Be sure to provide the owner with all of the
paperwork that came with the kit.
1. Check air pressure weekly.
2. Always maintain normal ride height. Never inflate beyond 100 PSI (7BAR).
3. If the system develops an air leak, use a soapy water solution to check all air line
connections and the inflation valve core before deflating and removing the air spring.
Minimum Recommended Pressure
5 PSI ( .34BAR)
FOR SAFETY AND TO PREVENT POSSIBLE DAMAGE TO THE VEHICLE, DO NOT EXCEED
MAXIMUM GROSS VEHICLE WEIGHT RATING (GVWR) OR PAYLOAD RATING, AS
INDICATED BY THE VEHICLE MANUFACTURER.
ALTHOUGH THE AIR SPRINGS ARE RATED AT A MAXIMUM INFLATION PRESSURE OF
100 PSI (7BAR), THE AIR PRESSURE ACTUALLY NEEDED IS DEPENDENT ON LOAD AND
GROSS VEHICLE WEIGHT RATING.
Maximum Air Pressure
100 PSI (7BAR)
17