LoadLifter 5000 Series
Installing the LoadLifter 5000 Series System
GETTING STARTED
COMPRESSED AIR CAN CAUSE INJURY AND DAMAGE TO THE VEHICLE AND PARTS
DANGER
IF IT IS NOT HANDLED PROPERLY. FOR YOUR SAFETY, DO NOT TRY TO INFLATE THE
AIR SPRINGS UNTIL THEY HAVE BEEN PROPERLY SECURED TO THE VEHICLE.
1. Raise the vehicle and support the axle with safety stands, setting the safety stands
2. Drop the axle or raise the frame up to make room for the assemblies to be put into
3. Remove and discard the line holder located on the left (driver's) side of the frame rail
NOTE
Late model line holders may look different than the one pictured in Figure 3.
4. Pull up on and remove the pin holding the line holder in place on top of the frame
MN-1045
as wide as possible on the axle (fig. 2).
position between the frame and axle.
on the inside of the frame, just forward of the axle (fig. 3).
(fig. 4). Unhook the lines and remove the line holder. Discard the line holder.
fig. 2
Inside frame,
left (driver's)
side view
fig. 3
Outside frame,
left (driver's)
side view
fig. 4
5