Change The System Pin; Set The Memory Keys - Geemarc COMBI DECT 295 Photo User Manual

8.2.9

Change the System PIN

1. Press MENU/OK and /
2. Press MENU/OK and /
3. Press MENU/OK and you are requested to enter the 4-digit system PIN.
4. Enter the old system PIN.
5. Press MENU/OK and enter the new system PIN.
6. Press MENU/OK and enter the new system PIN again.
7. Press MENU/OK to confirm.
8.2.10 Set the Mem ory Keys
There are three photo speed dial memory keys 1, 2, and 3 and 1 speed dial
memory key M4 on the right side of the telephone base for you to store frequent
use numbers.
After a number is stored in any of these memory keys, you can simply press once on
one of these memory keys to dial out to the number stored in it directly.
Using the base:
1. In idle mode, enter the telephone number you w ant to store.
2. Press and hold any of the memory keys until you hear the confirmation tone to
indicate the number has been stored.
To insert a photo:
You can insert a desired photo into the compartment of the three photo speed dial
memory keys 1, 2, and 3, or w rite the contact name on the photo speed dial card.
1. Crop your desired photo to the size as indicated below.
2. Put the cropped photo into the photo speed dial compartment. Then flip dow n
the photo speed dial compartment cover.
21.95 mm
to select SETTINGS.
to select CHANGE PIN.
33
BOOS†ER