Registration - Geemarc COMBI DECT 295 Photo User Manual

8.3

Registration

Your handset and base station is pre-registered. Up to five handsets can be
registered to a single base station.
If for some reason, the handset is not registered to the base station (
w hen the handset is near the base station), register your handset according to the
follow ing procedure.
On the photo handset
On the Base: First place the base of the AMPLIDECT295 or AMPLIDECT COMBI 295
in Registration mode.
Replace photo handset back on the charging pod, the red LED flashes quickly to
indicate registration in process.
You w ill hear a confirmation beep w hen the registration process completes. It takes up
to 60 seconds to complete the registration.
Note: if the handset doesn't arrive un registered, please f ollow this procedure:
Handset: Quickly press [VOL+] [SPK] [VOL-] [SPK] [VOL+] [VOL-] [SPK] in idle
mode, then HS w ill have a "Bi,Bi" tone.
On the standard cordless handset:
1. Press MENU/OK
2. If you have more than one base, press
number from BASE 1, BASE 2, BASE 3 and BASE 4. There w ill be a
behind the current registered base number.
to display "PIN?", enter the 4-digit system PIN for the base
3. Press
(default PIN is 0000).
and the display w ill show "WAITING".
4. Press
5. At the same time, press MENU/OK and /
select REGISTRATION.
6. Press MENU/OK to see "PLEASE WAIT" flashing on the base display. After a
short delay, if the registration is successful, there will be a confirmation beep,
and the handset display w ill go back to idle mode w ith the new handset number
show n. The base display w ill also go back to idle mode.
7. Press INT/MUTE/CLEAR at any time to cancel.
and / to select REGISTRATION.
34
and / to select the base
on the base to
flashes even