Advertisement
R
If using the standalone installation the log application should be started up first followed by the view and in
all situations the log application must be running for the system to work.
3.2 THE ELCOMONITOR LOG APPLICATION
Begin by installing the Log Application onto your PC and following the on screen wizard. Once this is
complete, open the application.
The main screen will list all of the Climate Stations that the application has made a connection to via
Bluetooth or over a network. It will initially be empty as no stations have been added yet.
Search for Climate Stations via Bluetooth
If your PC is Bluetooth enabled you may connect to a Climate Station with this method when in range. The
button opens a wizard that allows you to find stations in range. The search process may take a
few minutes. Once complete, the application will indicate the stations located (if any) and checking the box
next to them will add them to the log. Click the Finish button to close the wizard
If the wizard is unable to find the Bluetooth Climate Station try again. Repeated failures may indicate that
the station is out of range.
Search for Networked Climate Stations
The application can search for Climate Stations hardwired to the same network with the
button.
The wizard will search a range of IP addresses on a network and attempt to locate a Climate Station at
each address. This process will take several minutes to complete. Any new stations the wizard has found
5
Advertisement
