Advertisement
R
Proceeding through the wizard by pressing next will go through all of the different measurement types and
allow the user to set tolerances for each of the parameters in this way.
After all of the parameters have had their tolerances set the parameter that will be displayed on the signal
tower and activate the audible alarm must be selected. Any parameter that has had limits set may be
selected.
Parameters may also be defined in the wizard that will override the normal operation of the signal tower if it
enters a red tolerance zone. This will cause the red light on the tower to flash and the alarm to sound. The
flashing light will persist until the parameter has reached a yellow or green state. The signal tower will then
show the condition of the usual parameter as normal.
At the same time as the signal tower changes colour, a new event will be displayed in the Elcomonitor
View software. This will pop up each time one of the parameters has shifted into another zone or when a
station is powered up to alert the user if they need to change anything.
15
Advertisement
