Flex Port Module - HP EliteDesk 705 G4 Maintenance And Service Manual

Flex port module

For a list of available flex port modules, see
A flex port module can be installed near the back of the system board that provides an additional connector
on the rear I/O panel.
To remove the flex port module:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the rear fan
4. Remove the two Phillips screws (1) that secure the module to the system board.
5. Lift to disengage the module from the system board connector, and then remove the module from the
computer (2).
To install a flex port module, reverse the removal procedures.
Computer major components on page
(Preparation for disassembly on page
(Access panel on page
(Rear fan on page 30).
18).
5.
17).
Flex port module 31