Installing A 3.5-Inch Hard Drive - HP EliteDesk 705 G4 Maintenance And Service Manual

4. Pull the release lever next to the rear of the hard drive outward (1). While pulling the release lever out,
lift the rear of the drive up (2), and then slide the front of the drive back and lift it out of the bay (3).
To remove a 2.5-inch hard drive installed in an adapter bracket, pull the release lever next to the
●
rear of the bracket outward (1). While pulling the release lever out, lift the rear of the bracket up
(2), and then slide the front of the bracket back and lift it out of the bay (3).

Installing a 3.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Install mounting screws on the sides of the hard drive using standard 6-32 silver-and-blue mounting
screws.
46 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page 18)
17)